Adam’s UV Leather & Vinyl Coating – 50 ml

Description

Adam’s UV Leather & Vinyl Coating – 50 ml

Adam’s UV Leather & Vinyl Ceramic Coating is our first offering of a ceramic coating for interior surfaces! Much like our other UV ceramic coating offerings, the UV tracer allows you to see where the coating is applied when used with the Adam’s UV Flashlight. Adam’s UV Leather & Vinyl is specifically formulated for natural, sealed and synthetic leathers and vinyl surfaces including your dash, door panels and other hard interior surfaces. This product is not suitable for aniline leathers or for use over the top of Adam’s Leather Conditioner!

• Patent Pending, UV Tracing Technology™
• Rapid Cure – Fast Flash & Low VOC
• Extremely Easy to Use – Wipe On / Wipe Off
• Provides Extreme Hydrophobicity, Wear and UV Protection
• 50 mL Bottle Does Multiple Automotive Interiors

Advantages:

• A Little Goes A Long Way
  Apply to your entire vehicle’s interior!
• Super Hydrophobic
  and not to mention long-lasting.
• Glows Under UV Light
  Using our Ceramic Glow Technology.

Description:

Adam’s UV Leather & Vinyl Ceramic Coating provides semi-permanent protection to surfaces via the curable ceramic resins loaded into the easy to use formula. The active Ceramic Glow Technology™, with use of the Adam’s UV Flashlight, provides unrivaled levels of visibility of the coating during and after application for peace of mind that the coating has been thoroughly applied and is providing lasting protection.

Adam’s UV Leather & Vinyl Ceramic Coating will provide leather seats and other hard interior surfaces protection from everyday wear and tear, ultraviolet damage, jean transfer, color fading, stains and spills. This coating is at its best when it is used proactively to prevent damage and is not as good for use on already deteriorated surfaces.

Instructions for Application & General Use:

Utilize any of Adam’s Leather & Interior Cleaner, Adam’s Interior Cleaning Wipes or Adam’s All Purpose Interior Cleaning Gel with an Adam’s Interior Microfiber Towel to ensure surface to be protected is clean and dry before application of the coating.
Lightly saturate a Gray Suede Applicator or similar with numerous drops of the coating.
On a subsection of surface to be protected such as part of a seat or door panel, wipe the applicator across the surface using a cross-hatch motion with slight overlap to sufficiently ensure coverage. Using the Adam’s UV Flashlight in this step helps ensure proper leveling and coverage.
After allowing the coating to flash or volatilize and penetrate for 60 seconds, wipe excess material from the surface until dry using a clean, dry Adam’s Interior Microfiber Towel or an Adam’s Suede Microfiber Towel. The coating should be dry to the touch and a uniform blue glow should be evident on the subsection when using the Adam’s UV Flashlight.
Repeat alternating Steps 2, 3 and 4 on additional surfaces until it is evident that all areas requiring protection are complete.
If any unpleasant odors are present, ventilate vehicle and odor will dissipate. Odor is not harmful or hazardous.
When Cleaning a Spill:

To preserve the life of the coating and promote maximum durability, blot out spills with a clean, dry microfiber towel and avoid aggressively rubbing the surface.

Common Sense Warning:

Adam’s UV Leather & Vinyl Ceramic Coating is a semi-permanent ceramic coating and should not be used on any textiles or aniline leather surfaces due to their fibrous nature. The coating will ruin the look and feel of these surfaces and won’t perform as intended. Always apply a coating to an inconspicuous area first to ensure compatibility.